Farmall & IHC Tractors Discussion Board |
Int 350-C175 Pistons
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave on March 14, 2003 at 21:20:00 from (172.143.115.194):
I recently rebuilt my 350 utility engine. It has a c-169 block, but everything in it was 175 size (Sleeves, pistons, wrist pins, etc.). My question is this. The pistons I took out of it were in bad shape, both out of round and the ring grooves were chipped. But the top of the pistons were not flat. They had a high rise shelf more or less (not really a crater). The new pistons that came with my sleeve kit were flat. Do these type pistons reduce the HP due to less compression?? The old pistons did have the bushings in them for the smaller wrist pins. New pistons I didn't need the bushings.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|