Farmall & IHC Tractors Discussion Board |
5th Gear on my IH 504 Utility
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark H on March 14, 2003 at 06:53:39 from (208.30.22.113):
My 1964 IH 504 utility has a real hard time pulling into 5th gear. Of course the only time I use it is when I drive down the road to the neighbors to help him out. 4th gear runs just fine but when I go to 5th the engine drags and doesn't get up to speed. I have tried to slip the clutch real slow to let the engine rev up. If I am going downhill it gets up to speed after a while but on flat land I just end up dropping it back to 4th. Other than that the engine and tractor is real strong. Something I can do or is it something I should be concerned about? Like I said I don't use 5th much but it would get me to the neighbors a little faster! Thank you!
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|