Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: IH460 issue with going to more than half trottle quickly.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ernie Bob on March 13, 2003 at 22:50:59 from (198.81.27.16):
In Reply to: Re: Re: Re: IH460 issue with going to more than half trottle quickly. posted by Dave Gibson on March 13, 2003 at 21:28:14:
Dave, The flapper valve that you're talking about is called a heat riser. I'm not sure how it works on the IH engines but on the early Ford's it would stay closed on one side of the exhaust manifold on a V8 causing the exhaust to travel through a port under the intake manifold to the other side exhaust manifold and heat it up faster. When the exhaust got hot enough the valve would open allowing the exhaust to exit freely and it will remain open during normal operating conditions. I believe the spring that you're talking about is the temperature spring the holds the valve closed when cold and will gradually open the valve as the engine heats up. Hope this helps! Ernie Bob
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|