Farmall & IHC Tractors Discussion Board |
Re: Farmall A engine questions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steven@nd on March 12, 2003 at 08:12:41 from (165.234.132.118):
In Reply to: Farmall A engine questions posted by Jod on March 12, 2003 at 06:00:34:
I use the spray on sealer, it also comes as a brush on. Any auto parts store should have it on hand. 2-copper rings are for the valve cover bolts, go under the nuts. When I set valves I warm the engine up good, shut it off and set them. Crank the engine until 1 valve is open on #1 cylinder, set lash on the other valve, then crank until the valve you just set is open and set the other one. Fool proof way of doing it (if one valve is all the way open the other HAS to be closed). Be sure to recheck valve lash after a few hours of running time. My H was WAY off on valve lash after 5 hours run time. Oh yeah, warm engine up and let cool and retorque head again - you'll need to reset the valves at that time again too.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|