Farmall & IHC Tractors Discussion Board |
Re: Farmall A engine questions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Doug in NJ on March 12, 2003 at 06:15:32 from (67.81.52.249):
In Reply to: Farmall A engine questions posted by Jod on March 12, 2003 at 06:00:34:
I believe the copper rings fit into machined holes on the top of the engine block. You'll see the holes when you take the head and old gasket off. I used black spray paint as a sealer on my head gasket. This was suggested by some on this board. It was mentioned that most race car crews use the spray paint, so I figured it had to be OK. So far, it seems to be working just fine. Can't help you regarding the valves. Don't know much about them. Good luck, and have fun!
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|