Posted by karl f on March 29, 2009 at 11:29:55 from (172.130.27.44):
the idle mixture screw on our 400 gas does not affect the idle at all. it runs fine, you can drop it down to about 300 rpm if you want. However, it idles pretty smoky, smells bad too. If you try to start it at lowest throttle even when speed set correctly to about 450, it will overchoke and flood. Also, if you partially remove idle mixture screw, the tractor all of a sudden will idle fast. But, if you completely remove screw it will die. This was a running tractor (always hard starting, rich idle, throttling up even one notch when cold would kill it). I partially disassembled the carb to check float adjustment and other things, and then synchonize governor/carb. I suppose it is a passage i didn't make time to ream out, but which one? I think it is the correct carb for the tractor, the main discharge jet is removed with a nut inside the bowl vs. a screw head on the outside.
thanks for your input. karl f ps i found one float set higher than the other.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.