Farmall & IHC Tractors Discussion Board |
Re: Re: starting a S-MDTA
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jerry on March 08, 2003 at 10:24:13 from (216.251.173.80):
In Reply to: Re: starting a S-MDTA posted by Bob M on March 08, 2003 at 07:44:50:
Your sequence is correct except that I believe only the earlier ones used the lever forward for diesel and back for gas. I had a 1950 MD and that was gas ahead and diesel back. I think the SMTA diesels were the same. One very important thing is to warm them up good and cool them down good. I always let my MD cool down for several minutes on diesel, then switch to gas for a few minutes. If your diesel throttle is shut off properly you can just pull the gas/diesel lever back and the engine will stop with the starting valves closed.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|