Farmall & IHC Tractors Discussion Board |
Re: H wont stay in fifth gear
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bryce Andreasen on March 05, 2003 at 20:00:26 from (209.74.224.24):
In Reply to: H wont stay in fifth gear posted by Farmall Ed on March 05, 2003 at 05:11:41:
I have a '41 H and had the same problem you had. Well i ended up having to buy a hole new 4th and 5th sliding gear, but i doubt you have to. with mine, the main gear that the fifth gear goes onto and that runs the trans, and belt pully, looked like someone pulled it behind a pickup for twenty miles. The bearing had wore a groove an eigth of an inch down on one side, and was breaking the pilot bearing. So there was nothing supporting that end. There fore, it would come out of fifth. One way to test this out, is to start going down hill in second gear, if the bearing is out, it will make a loud knocking noise from the shaft hanging down and hitting the reverse side gear.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|