Farmall & IHC Tractors Discussion Board |
Re: first restoration project, questions about H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Larry F on March 04, 2003 at 22:03:27 from (216.202.132.34):
In Reply to: first restoration project, questions about H posted by mike in PA on March 04, 2003 at 20:24:31:
Mike - The pulley will have to come off to remove the front cover. I'm not sure you'll gain much though by removing it if all you are doing is trying to clean up the engine. Its pretty straight forward and you may not even need a puller..I didn't. Just make sure you note everything as you take it off..have heard of guys who button everything up only to discover they left an oil slinger out or some other obscure part. A parts manual is very helpful in showing the way everything fits together. The valve cover and oil pan come off easily enough and cleaning up under them is easy. Not sure why the water jacket uses those studs but thats the way they came from the factory so I restored mine that way. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|