Farmall & IHC Tractors Discussion Board |
Re: Head repair??????
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Draw Bar on March 04, 2003 at 16:41:39 from (152.163.189.203):
In Reply to: Head repair?????? posted by Antique puller on March 04, 2003 at 16:04:54:
Nope , I never tried it. However I was told that it worked really well. The old timer that told me how he did it said you start at the edge of the crack,drill a hole ,tapp the hole,then install a stud with locktite in the hole. Drill your next hole so that it removes part of the stud you just put in. Keep working your way across the crack in the same manner until you have covered the crack completly. Of corse you have to cut off and grind down each stud as you go. Sounds time consuming to me, but I guess if it's a hard to find head and and it's not cracked up to bad. It might be worth a try. Good luck!
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|