Farmall & IHC Tractors Discussion Board |
Re: 3-point post hole digger on H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Irv on March 03, 2003 at 16:48:45 from (152.163.189.203):
In Reply to: 3-point post hole digger on H posted by Larry F on March 03, 2003 at 08:03:18:
I put 1 on my H last year - It works great, will go down the full 4 ft. in 20 seconds or less. I have only 2 warnings about this: 1) These things are extremely dangerous. I have operated it alone, but I would not recommend it. If it got a piece of you, even a sleve or pantleg, it could get ALL of you. 2) I had a hard time getting the auger to go in square from the seat. Much better for an operator and a spotter. Also much safer. 3) I had to use a bungee cord to tie it up for transport. Otherwise it hits the ground when you transport. 4) I have a Saginaw hitch on my H. It has downpressure, and the belly pump provides plenty of power. I bough the the digger at TSC. Good luck & be safe!!!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|