Farmall & IHC Tractors Discussion Board |
Re: H Grille Screen
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BIG JOHN on March 02, 2003 at 15:59:43 from (205.188.209.78):
In Reply to: H Grille Screen posted by Bob Mills on March 01, 2003 at 21:32:15:
The screen is 3/16" Hail Screen that you can get from a good full service Hardware Store. Most of the chains don't carry it but they have the 1/8" and 1/4". Just cut the screen away from the spot welded clamps and streighten the prongs and remove the screen. Use the old screen flattened out for a size pattern and cut your new screen that size. I start on one side and put it on the prongs when I get to the ribs I use a clamp type (3" wide jaws) vice grip pliers to form the screen around the ribs and then to hold it in place and I use just a small amount of JB Weld to attach the screen to the ribs. I usually form and attach the screen completely and then go back and do the JB Weld, leaving the clamps in place until the JB Weld hardens. This has worked well for me on several grills. GOOD LUCK!!!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|