Farmall & IHC Tractors Discussion Board |
Re: Fast Hitch question's on implement prong width size
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on February 19, 2003 at 02:29:22 from (216.208.58.153):
In Reply to: Fast Hitch question's on implement prong width size posted by Ray in PA. on February 18, 2003 at 21:10:14:
Ray: I don't believe there were ever two widths in fast hitch, at least up to end of 460-560 production. Here is what I know. My 300 and 560 were both same width and same prong size. My brother has a 230 with fast hitch, plow, rear blade and mower. That hitch is same width as 300 and 560, however prong size is smaller, by 1/2 inch in depth and 1/8 inch in thickness. The implements from smaller hitches on SC, 200 and 230 can be used on larger tractors using a 1/2 inch filler plate under the prong. This is probably not much interest to you but on single point hitch on offset Farmalls, Cub uses the small prong and SA, 100, 130 and 140 use the large one.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|