Farmall & IHC Tractors Discussion Board |
Re: Very New to a Super M Wide front tractor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Barnstormer on February 18, 2003 at 17:36:13 from (67.26.12.28):
In Reply to: Very New to a Super M Wide front tractor posted by Willy-N on February 18, 2003 at 17:12:26:
Hi, Mark. I saw your post on the N board and thought I would drop in here. I have a Farmall H and enjoy it for some special tasks like hayrides. It sits up higher so I can see both wagons full of people. The H (and I'm sure the M) used "pull" type or trailer equipment. The exceptions that I am familiar with are the cultivator and a semi-mount sickle (hay) mower. These worked off of the internal hydraulic pump that feeds three ports. For the cultivator, two ports feed the front gangs and the third port feeds the rear gang. The rear gang was a delayed lift so that it scratched the soil behind the tires to the end of the row. My current H has an external pump on the right side of the engine. It provides live hydraulics though I currently do not have any implements for it. It has hoses that feed back into the internal distribution system of three outlets and is controlled by the standard control lever. Hope that helps.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|