Farmall & IHC Tractors Discussion Board |
Re: Re: Super H clutch
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CNKS on February 13, 2003 at 18:15:14 from (207.178.96.214):
In Reply to: Re: Super H clutch posted by Andy Martin on February 13, 2003 at 15:25:19:
That is what the book says and what I intended to do-- compress the plate with every other bolt. The cover which holds the springs is bolted the the flywheel -- six bolts, I think. If I remove all the bolts, what happens? Looks like all the springs come out, and go who knows where? Then I remove the pressure plate and disk? There may be holes under the cover (book doesn't show them), but I promise you there are none in the cover -- what am I missing? The clutch in my Super H is the one used in the H from SN 391358 up, they only made H's through SN 391730, so this one is removed a different way? The parts book for the H (up to 391358) does show holes in the cover and in the pressure plate, the page for the clutch I have doesn't. Look at page 106 of your H parts manual. There are no holes in the 9 fittings the springs fit over. I have never worked on a clutch in anything before. Thanks for your help.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|