Farmall & IHC Tractors Discussion Board |
Re: splitting a 1206
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Yellott Canby on February 08, 2003 at 17:06:55 from (216.158.80.26):
In Reply to: splitting a 1206 posted by Bill on February 08, 2003 at 14:13:00:
Hello, I have never split a 1206 but I found the easiest thing to do on most tractors is to take an hour or so and weld up a set of stands to fit. I split a large Massey ( 1130 ) and I drilled and bolted some oild heavy angle iron to the fron and back halves, the angle going straight down to the floor. Then welded some cross braces on the uprights and also ran a brace from the front of the tractor at an angle down to the bottom of the upright angle iron. This kept the stands from folding. I think I even tacked on a couple of old casters to the stand on the front end and after unbolting it just rolled it forward. It sounds involved but didn't take long at all. I had a lot of scrap steel around so had no cost in it. Trick is to bolt the braces to the tractor then weld them to each other. That way is quickest and you know they will fit. Good Luck! YC
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|