Farmall & IHC Tractors Discussion Board |
Stuck 806D
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ismael G. Lerma on February 06, 2003 at 15:23:31 from (63.84.63.109):
I bought A 806 that had water in the engine. I removed the injectors and vacummed out as much of the moisture I could and then blew each cylinder out with air and squirted a few cans of pb blaster into the cylinders. How long should I let it soak and what is the best way to try to turn it. I thought the crank pulley but I don't know if I would damage the rubber in the pulley. Also afraid of breaking gear teeth if I pry too hard on the starter gear. Also a friend said to use hydrogen peroxide to free the engine. Has anybody heard of this before. All advise is greatly appreciated.
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|