Farmall & IHC Tractors Discussion Board |
Re: Re: loader tractor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Del on February 04, 2003 at 20:37:35 from (209.62.165.33):
In Reply to: Re: loader tractor posted by Tom W on February 02, 2003 at 16:52:50:
I have a Bush Hog 2400 QT on my 574 utility. It took a little adaptation and I made some nice heavy duty brackets (heavy wall pipe welded to 1/2 inch flat plate) I also made some plates to tie the front and center brackets together. The loader fits the tractor nicely. I have some pallet forks also. Others in the area have gone with the Dunham Lehr 22 loader, but so many of them cannot handle the twisting so they crack. When you make/ buy brackets for the loader, try to get those that can tie the front section of the tractor to the midsection. I've heard stories of tractors being split from loaders putting too much pressure on just the center of the tractor. If you decide to go that route, maybe I could email you some photos. Just 2 cents worth. Good luck
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|