Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Hydraulic Fluid in Oil Pan
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on February 03, 2003 at 06:15:55 from (165.170.128.68):
In Reply to: Re: Re: Hydraulic Fluid in Oil Pan posted by Andy in MN on February 03, 2003 at 05:34:34:
Andy - To set to TDC first mark the outside of the distributor housing where the #1 plug tower is the dist cap. Then remove the distributor cap, but leave the rotor button in place. Now "bump" the starter while watching the distributor rotor. Stop when the rotor terminal nears the mark you made on the dist housing. Finally grab the fan blade and use it to manually turn the engine the last bit to TDC - indicated when the pointer on the timing gear cover lines up with a notch mark on the crank pully. (Sometimes it helps to remove the spark plugs for this step...) Now if you don't disturb the crankshaft with the hyd pump removed, all you need do is make sure the distributor rotor lines up with the mark on the housing when the hyd pump/distributor are back in place.
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|