Farmall & IHC Tractors Discussion Board |
Farmall H Steel Wheels Questions!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scott L. Swanson on January 31, 2003 at 11:16:52 from (209.180.31.9):
I am changing a 1942 Farmall Distillate over to Full Steel. I found another set of rear steel. They are the 10" wide variety with 56 lugs and 51" across. How do I hunt up a 5th Speed lockout bolt to prevent my or other's shifting it into 5th and risking monster injury? I have advertized for one for three years. Does anybody out there know the dimensions of just such a bolt? Did the Front Steel Wheels come with skid rings standard or were they usually provided without? Both of my two sets of front steel have the skid rings installed in two differet configurations. What is the proper configuration for the skid rings? Skid in the middle or skid to one side? Any ideas out there? Thanks, Scott
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|