Farmall & IHC Tractors Discussion Board |
Re: Are my 1940 H's Valves in Good Shape?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill L Md on January 30, 2003 at 14:35:30 from (68.55.41.86):
In Reply to: Are my 1940 H's Valves in Good Shape? posted by michael leipholtz on January 30, 2003 at 14:06:32:
Mike, dose the tractor run? If so does it run well? If it runs well and dosn't miss then I would say that their is nothing wrong with your valve train.Was their somthing that caused you to remove the dome cover?What you are looking at is the top end ,basically valve spings and oil galleys, you can run your H with the dome cover off and make sure that all of the valves are opening and closing and that you are getting oil up top to lubricate the rocker arms.If the amount of sludge is a problem then you can scape it out but you must change the oil when you do this,not changing the oil enough is what caused the sludge.You can also run an oil kerosene mixture through the engine to clean it out.4qts oil 1qt kerosene.Do not run this in the tractor to long it may damage you bearings,you may want to drop the pan after this to make sure all debris is out,then put fresh oil and filter back in the crankcase and run it.you may have to change the oil a couple times to get any small particals out of the system.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|