Farmall & IHC Tractors Discussion Board |
Re: New Clutch for Farmall B
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on January 30, 2003 at 03:57:02 from (166.72.245.37):
In Reply to: New Clutch for Farmall B posted by Dan on January 29, 2003 at 20:14:40:
If your clutch pressure plate is not totally shot, why not have it rebuilt. If the release fingers, etc are still good, that will be cheaper than a new one. I take my tractor clutches to a local clutch brake rebuilder. He puts in new springs if needed, resurfaces the pressure plate, and relines the clutch disk. He usually even has a release bearing in stock that will fit. With the B, you may need a new clutch release bearing carrier since the B was originally not equipped with a ball bearing there. You can get that from an IH dealer or one of the aftermarket suppliers like Val-U-Bilt, etc. Also, the pilot bearing is a special bronze bushing, I suggest getting that from an IH dealer to make sure it is correct. One of my tractors had one that was not IH, and it came out of the socket in the end of the crank shaft. It is supposed to be a press fit.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|