Farmall & IHC Tractors Discussion Board |
Re: road gear question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gerald on January 29, 2003 at 19:27:13 from (66.94.138.1):
In Reply to: road gear question posted by Gary- The Rookie Farmer on January 29, 2003 at 18:54:22:
Gary, I will assume you have an M. With my M I start out in 4th gear, open the gas throttle up to 3/4 full, then push in on the clutch and reduce the throttle while shifting from 4th to 5th gear, then let out on the clutch and give it some gas. The trick is to do this before the tractor stops moving forward. I do this especially when I am pulling anything. My uncle had the tractor before me, buying it new in 1945. He and I have been doing the 4th to 5th gear shift all this time without any harm to the tractor. This is very important.....No matter how you get going in 5th gear, make sure your brake peddles are locked together!! Enjoy your tractors, Regards....Gerald
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|