Farmall & IHC Tractors Discussion Board |
Re: 300 to M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dick Davis on January 29, 2003 at 05:02:29 from (152.163.189.203):
In Reply to: 300 to M posted by Daniel T. Maxey on January 28, 2003 at 20:44:11:
As far as the Fast Hitch goes, Nope. The fast hitch bolts into holes cast into the differential case. Of the M series only the SMTA had those holes. The 300 was the same width as an H so would be too narrow for an M as well. So if you're looking to salvage the 300 stuff you might combine it with an H an build one of those mythical Super H TA's we all are looing for. If you're looking to upgrade your M you might try and add a live hydraulic and an after market three point. Not sure if the distributor driven hydraulic pump from a 300/350 will fit on an M/400/450? But I expect someone else herein will know for sure. Good Luck Dick
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|