Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Working on Farmall H safely!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on January 24, 2003 at 19:52:46 from (63.147.130.79):
In Reply to: Re: Re: Working on Farmall H safely! posted by Scott Swanson on January 24, 2003 at 09:55:52:
O.K. so strike the splitting the tractor. I understand you not needing to do that. My point was also intended in this way. Once you get tractor upside down, then what. You are going to be lifting those heavy parts up and out of the tractor and then lifting them up and back in. You are probably still going to need a chain hoist or cherry picker to lift out the hydraulic lift all. And sooner or later you will need a hydraulic jack for removing wheel's or something. I still think you are better off not making your flipper over becuase the tractor is probably going to go KA Flop real fast becuase it will be bottom or top heavy and that in itself will probably be more dangerous then leaving tractor upright and working underneath of it. Especially since the lift all will probably be the only real heavy item since you are not splitting. I would sure hate to see your tractor and your flipper over and everything laying on its side on the floor with you underneath the first time you flip one over.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|