Farmall & IHC Tractors Discussion Board |
Re: dent in gas tank
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Air Compressor Guy on January 22, 2003 at 18:03:45 from (12.45.76.149):
In Reply to: dent in gas tank posted by rob on January 20, 2003 at 20:11:04:
Just want to expand on the DON'T USE AIR PRESSURE theme. I've been designing ASME pressure vessels for an air compressor firm for a number of years now and have investigated the aftermath of catastrophic failures... not pretty. If you enjoy the roof on your garage, not to mention parts of your body, don't mess with it. Since we are here, care must be taken with your air compressor tank. Most tanks are design to last only seven years (statistically this almost eliminates the catastrophic failure mode). If you have an air compressor and it is more than seven years old you may want to consider purchasing a new tank for it. Also, under no circumstance should you weld to it. When you weld to it you need the arc to be at the right intensity, use the correct wire and shielding gas, and use the correct steel alloys. We use specialized techniques with highly trained welders to make our pressure vessels, quite honestly it's the only thing keeping our operation from not shipping out to China (much to the dismay of upper management). My final note before I get off of my soap box. If you own a compressor who's tank was manufactured in China I would stop using it immediately. I have not come across a tank from China that does not have serious design flaws, and I have looked at dozens of examples. Remember in China it's all about how many units you can produce in an hour, they view people as being replaceable.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|