|
Farmall & IHC Tractors Discussion Board |
Small Water Pump to Fan Springs on H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by George on January 20, 2003 at 21:15:52 from (206.230.105.250):
I am just replacing the water pump on my Farmall H. I was able to get a used one, but the tractor has been broken down for half a year now because of it. There is no way i would spend the almost $300 the local shop told me it would cost for a rebuilt pump. I finally found a good used one, but then I had to order the gasket. That took six weeks. Then I needed hoses, another month, then another part, and another month, etc etc...
I will never order from this local shop again. So, I finally got the tractor in the garage, and was all ready to replace the pump, and I find out that there are two small springs that go between the fan and the cast iron piece on the end of the pump shaft. I went to a local hardware store to look for some generic springs, they didn't have anything to fit. I planned to go to the "city", only to find that I have lost the broken springs.
Arrrgggghhhhhhhhhhh........ Can anyone tell me the proper diameter and length of these springs? I think I can take a good guess at the spring tension. I dont think this is real critical. I need the tractor, because if we get a heavy snow, that is my only way out of my 1/2 mile long driveway, and honestly, enough is enough, and there is no way I am going to wait another month or two to get them from the local shop, or mail order them. Can anyone help please !!!! Thanks George
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
