Farmall & IHC Tractors Discussion Board |
Re: farmall sc fast hitch
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan(VA). on January 17, 2003 at 17:52:13 from (208.59.156.171):
In Reply to: farmall sc fast hitch posted by IH Puller on January 17, 2003 at 12:29:37:
derek, If the pipe you're referring to is off the front of the fast hitch, going up to a stud on the side of the torque tube; then yes, it controls front to back tilt. It is usually just pinned to that stud which holds it in a fixed position. You probably don't have it any longer, but there is supposed to be a cast iron rod that slides down in that pipe when not in use, or you pull it out and attach it to the right hand rockshaft when you need to control the tilt angle. That is why all fast hitch equiped tractors have a different right hand rockshaft with a second attachment point part way down the side of the rockshaft. The arm that comes up the other side of the tractor controls the side to side tilt angle, and your remote hyd valve controls the main lift. Stan(VA).
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|