|
Farmall & IHC Tractors Discussion Board |
Re: duals
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on January 16, 2003 at 13:14:50 from (63.147.130.49):
In Reply to: duals posted by Brian on January 16, 2003 at 12:06:54:
26Red is right. Put the inside wheel's on so that they are dished in. Instead of just simply turning them around and putting them on the same side of tractor, take the wheel off the left side and put it on the right side and take the wheel off the right side and put it on the left side, this will allow you to install the wheel with the tire tread staying the same. Turning wheel around will cuase the tread to be opposite as to the way it was. Slide the wheel in on the axle as far as nescesary to install the second wheel. Mount the second wheel dished out. As for extra parts, all you will need is an extra set of rear wheels. I have never tried it but I am fairly certain that it will not work with both wheel's dished out. You might thank twice about having duals. I have two H's, one with fluid in rear tires and one without. I can tell the power difference in the tractors just by the extra weight of the fluid in the one. Extra rear wheel's will allow for extra traction, more stability, smoother ride, and so on but will make tractor harder to turn and I am certain you will notice a little loss of power especially when going up hill. My personal opinion is, is that the H is to small of tractor with not enough power for duals. Tractor doesn't put out enough torque to justify the duals.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
