Farmall & IHC Tractors Discussion Board |
Re: 1466 Hydraulic Problem
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mitchissippi on January 16, 2003 at 07:30:00 from (67.32.248.87):
In Reply to: 1466 Hydraulic Problem posted by J Duke on January 15, 2003 at 16:44:03:
I have had a similar with the remotes on my 1066. I was pulling a dirt bucket and would have to wait on the gate to open. It had been opening fairly quick and I could dump the dirt where I wanted without slowing down the tractor. I got to looking for some kind of speed adjustment and found that the roll pins in the shaft at the bottom of the hydraulic levers were worn out. This slack wasn't letting me get full use of my levers. I replaced the roll pins and the gate started opening fast again. This may not be your problem, but it might not hurt to look in to it. Hope this helps, Mitch
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|