Farmall & IHC Tractors Discussion Board |
Re: Re: Conversion of M Cotton Picker toHigh Cropper
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wardner on January 15, 2003 at 12:56:49 from (67.25.174.127):
In Reply to: Re: Conversion of M Cotton Picker toHigh Cropper posted by randy hall on January 15, 2003 at 12:27:59:
Why do you say 5 mph? By flipping the differential ring gear and using the reverse operation deck lid and shifting forks, you will have five forward speeds. The cotton picker drop boxes with the gears will cut speed by about 75% (44 teeth divided by 57 teeth). Top speed in 5th gear will be about 12 mph. No match for a crop duster but it seems fast enough for field work. I beleive the 400-660 lid is the same as the previously mentioned lid but would need some machine work on a Bridgeport. The shifting forks, if not available, could probably be fabricated using the original forks
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|