Farmall & IHC Tractors Discussion Board |
Re: Re: Upper Bolster Revisited
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan(VA). on January 13, 2003 at 06:32:26 from (216.164.240.94):
In Reply to: Re: Upper Bolster Revisited posted by Bob M on January 12, 2003 at 19:16:03:
I'm just finishing this work on my Super H (thanks for the photos and earlier description, Bob). What got me started was when I took the loader off and installed a 3 pnt, a heavy load lightened the front end enough where it would clank as the nose bounced off the ground. I replaced all three bushings, most trouble was the lower pivot shaft and the one on the front supporting the worm gear. Used the hacksaw trick on the lower, was able to beat the upper out eventually. The upper pivot shaft bushing just slid out fairly easy. Hardest thing to re-install was the oil seal under the upper pivot shaft bushing in the wish-bone. As far as the vertical slack in the assy, I had the spacer, installed a new thrust bearing and still had the same problem. So I bought a couple 3/4" washers and used a boring head on a lathe to open the center to the dimention of the upper pivot shaft and installed them under the sector gear. I figured that would keep the normal worm/sector allignment but stop the clanking. I think I will go ahead with power steering while it's apart, and also updating to 12volts, fixing the radiator, replacing some gaskets and hoses while I'm in there. Stan(VA).
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|