|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Made in the USA, Does the US still lead in tractor mfg
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by James on January 12, 2003 at 08:57:42 from (65.171.7.152):
In Reply to: Re: Re: Re: Re: Made in the USA, Does the US still lead in tractor mfg posted by Icepick on January 12, 2003 at 06:11:34:
Sorry, Icepick, but I think you're wrong. I work in electronics manufacturing and my company has plants all over the world. Our locations in Mexico, China, Hungary, Malaysia, etc. pay their people pennies on the US dollar. Other locations like Singapore, Ireland, Puerto Rico, and Brazil are very comparable. It's all based on the standard of living in the location we're talking about. Management in these countries is compensated roughly in proportion to the US. If my industry is any indication, this economic recession has done more to damage manufacturing in the US than anything else. Consumers, and in turn, our customers (companies like HP, Dell, Cisco, Lucent, etc.) are demanding the lowest cost no matter what. That has required moving work out of the US and closing plants here. It's a continuous chain of events as long as people don't care where the manufacturing is going. You should hear the Mexican guys crying about the work moving from their factories into China because China is cheaper. Of course, it's all work that moved from my factory to Mexico five years ago. If you believe, as I do, that manufacturing is the engine of a good economy, this country is headed for trouble. Textiles and small appliances are almost all gone, electronics is moving, and heavy manufacturing is just beginning.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let’s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
