Posted by IH fan on March 28, 2009 at 20:35:53 from (208.189.33.152):
In Reply to: 240U rear weights posted by IH fan on March 28, 2009 at 13:12:15:
Looks like you got in a little deep, Dave!! My seat looks the same as yours... better than the original. Mine has the exhaust out the hood and my headlights (unwired at present) are moved to the loader crossbar.
My wheels are 24" and Mark thinks his are for 24" and is checking. I had the part number from my parts book, but don't know if it's on the weights anywhere. 24" weights are 63# and 28s are 65#... a little lighter than I thought, but 252# should help. I could hang some weight on the rear blade, but that's not as clean. Guy I bought the tractor from had a big old piece of iron about 500# hanging with chains on the 3 point... now I see why.
This post was edited by IH fan at 20:37:36 03/28/09.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
