Farmall & IHC Tractors Discussion Board |
Re: Re: Front Crank Seal Removal Super A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon Mirgon on January 07, 2003 at 18:02:55 from (66.119.33.135):
In Reply to: Re: Front Crank Seal Removal Super A posted by geoff gauger on January 07, 2003 at 14:36:58:
Geoff, Your front seal is just a press fit, take the front cover off and support the cover with some 4x4's underneath and use a screwdriver and a hammer and drive the seal out from the front, clean the inside of the cover good, and then carefully drive the new seal in from the back of the cover, when I install mine, after they are drove in, i use some Indian head, head gasket sealer on the back side, use the sealer on the metal surface of the cover to the metal surface of the seal.
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|