Farmall & IHC Tractors Discussion Board |
Re: Re-installing the Crank Pulley
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Roger on January 06, 2003 at 20:28:26 from (209.100.170.137):
In Reply to: Re-installing the Crank Pulley posted by Brian on January 05, 2003 at 16:57:51:
Brian, I have installed several of these. As someone said, there isn't a threaded hole in the crank on A's, B's, and C's. On those I first convince the wife I need to barrow the oven to heat tractor parts (promise they are clean and won't stink up the oven for next dinner). Then I heat them to about 250 degrees as I think if you get it too hot it will damage the oil seal. Then I drive it on as quick as I can with a 4x4 and big hammer. I don't think it is the best for the main bearings on the crank. On others with threads in the crank I pull it on with a bolt. Roger
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|