Farmall & IHC Tractors Discussion Board |
Re: Super HV: gear slipping
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by SAm in NS on January 03, 2003 at 12:44:05 from (24.138.71.44):
In Reply to: Super HV: gear slipping posted by R .A. on January 02, 2003 at 16:40:01:
I'm not too familiar with the H's but I might be able to help. First of all the clutch. There should be about 1" of travel in the clutch pedal before it starts to disengage the clutch. If you have a manual it should tell you how to adjust the clutch. If not (this is more of a guess than anything) look to see how the linkage goes from the clutch pedal to clutch, it probably enters the torque tube at some point and there might be an adjustment in there. About your 2nd gear, I think that is just due to wear and tear but I can't tell you what you can do about it. Are you sure you've got a Super HV because I don't think there were many made, 24 or 25 of them. Hope this helps. SAm in NS
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|