Farmall & IHC Tractors Discussion Board |
Re: TD-9 deisel pump prime
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on January 02, 2003 at 15:10:01 from (24.169.120.229):
In Reply to: TD-9 deisel pump prime posted by Roger A. on January 01, 2003 at 19:37:29:
Here's how to do it: 1 - With the main tank filled with diesel and the engine stopped, open the bleeder on the diesel water trap (if equipped) and the primary filter. Close when the bleeders flow fuel with no bubbles. 2 - Start the engine and let it run on gas, then open the secondary fuel bleeder until it flows air-free fuel. 3 - Now advance the governer (speed) control part way, then open the bleeder at each injector one at a time. BE CAREFUL HERE! - Don't let any part of your body get near the fuel that might escape from an open bleeder valve - it can be lethal!! 4 - Now throw the starting level to the "run" (diesel) position - if the system is air-free the motor will now run. Good luck!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|