Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: IH-6
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ron In NE on December 31, 2002 at 18:47:16 from (65.165.16.24):
In Reply to: Re: Re: Re: IH-6 posted by Wardner on December 31, 2002 at 13:35:12:
I don't want to butt in on a good argument, but I'm interested in hearing more from Wardner on the Elwood fwd setup. I haven't found anything about these in the archives. A neighbor has a 560 with an aftermarket fwd conversion, and it's the only one I've ever seen in person. Will this same conversion adapt to many different tractors? I'd like to find out more info on these. I once saw what looked like a W or WD-9 on the cover of an old magazine that appeared to have a fwd front axle under it. Same deal, or was this something that lots of local independant shops cobbled together on their own back then? Thanks in advance!
Follow Ups:
Home
| Forums
Today's Featured Article -
Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let’s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|