Farmall & IHC Tractors Discussion Board |
Re: FFA tractor restoration on TD9 dozer
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Milton on December 30, 2002 at 07:42:31 from (216.135.39.196):
In Reply to: FFA tractor restoration on TD9 dozer posted by Preston on December 29, 2002 at 16:19:22:
Hello Preston, --- 30 / Dec. / 2002 --- The motor SERIAL NUMBER is on a raised area (1/4 in) and is 3/4 in by 2 or 3 inches long - machine smooth area and has a SERIAL NUMBER which is machine stamped on it. The PREFIX letters should be "TDCBM". The grease and paint would have to be removed to read this. This is on the block, usualy up front right side of motor / but could be anywhere / right side - left side / but is on the block. Use paint remover to remove the paint. What ever the Prefix letters are / give that and the SERIAL NUMBER - OK? Regards, Milton
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|