Farmall & IHC Tractors Discussion Board |
TORQUE 756
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by len on December 26, 2002 at 19:04:44 from (208.153.180.195):
Let me try this question again----have a 756 IHC gas that I was driving with the torque lever in the forward position--direct drive---the tractor started loosing power and acting like it was pulling a heavy load when in fact it wasn't pulling anything pulled the lever back into the slower more powerful running position and it ran fine except being slower. Just prior to this happening I had run it a couple of miles in direct drive with the gas lever in the max position running it down the road a little faster than I usually drive it. This was a couple years ago and I have never tried to put it back into the direct drive position--lever forward. It works very well in the lever back position but it is a slower speed. I would like to get it into the direct drive position again and leave it there as I only use the tractor to do a little bush hogging about 10 hours per year. The light on the dash that tells whether I have hyd. oil pressure does not work--how is that light removed? Thanks for your help a few days ago thought I could give a little more info. concerning the problem.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|