Farmall & IHC Tractors Discussion Board |
WD9 Camshaft specs
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by chuck on December 25, 2002 at 20:16:06 from (161.184.19.161):
I have removed the cam from my WD9 and the lobes don't look too bad.The lobe heights vary from 1.771 to 1.777 inches.The lobes vary in sharpness and I am wondering if the intake and exhaust valve lobes have a different configuration? Starting from the front the lobes are rounded-sharp-sharp-rounded-rounded-sharp-sharp-rounded.Is this not the pattern that the valves sit in the head,in other words ,do the exh and int vales have different lobe configurations i.e.different degrees of opening? Would anyone have the camshaft specs for a WD9? Any comments appreciated
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|