Farmall & IHC Tractors Discussion Board |
Re: Farmall H gearbox , PTO shaft oil seals
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TimV on December 25, 2002 at 07:17:40 from (64.19.90.138):
In Reply to: Farmall H gearbox , PTO shaft oil seals posted by Sam Gerteisen on December 24, 2002 at 23:07:41:
Sam--not sure if I agree that stop-leak can't hurt anything. Most of these formulas work by chemically attacking the rubber of the seals, causing them to swell, and thus stopping the leak. The problem is that over time (and not a lot of time--often only a few weeks) they degrade the rubber to the point that it leaks worse than before. This can lead to other problems, such as shafts going out of alignment, excessive end or side play, and similar predicaments. However, on a transmission like the H, with relatively few seals, the worst that will probably happen is that you'll have to replace the seals eventually, which you probably would have had to do anyway. Hopefully this will at least get you through to warmer weather!
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|