Farmall & IHC Tractors Discussion Board |
Cant get my 44H started, need wisdom from Gurus
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by KURT on December 22, 2002 at 15:28:59 from (166.90.239.117):
Here is the whole story. A month ago my H wouldnt start, Gas normally leaked out of the bottom of the carb then would fire right up. (I have a 1/4" valve in the gas line to shut it off) Then 2 weeks later went to start it up again and gas did not leak out of the carb and I figured that there was a blockage, bought a rebuilt carb from a tractor part supplier, hooked it up and still does not start. I have good gas flow to the carb though. If I spray starting fluid in the air inlet it will fire about 4-5 times then nothing. I get an amperage draw when I turn on the switch. Gas is only 6-8 weeks old. Battery is strong, along w/starter. Ignition dist. is only 9 months old and doubt it is bad. Anybody have any other ideas on why this thing wont start. Need advice. thanks. KURT
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|