Farmall & IHC Tractors Discussion Board |
Re: replacement rims for 36 inch round spoke F+H wheels
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bus Driver on December 20, 2002 at 07:01:16 from (65.165.153.76):
In Reply to: replacement rims for 36 inch round spoke F+H wheels posted by J on December 19, 2002 at 18:52:07:
I sure hope that there will be some creative suggestions. I have one plan, but would like to have others from which to choose. I have not done this, but the procedure I have worked out would use a rim from a Super C. Remove the mounting clips, cut the center and narrow the rim to the desired width. Measure carefully the inside diameter of the rim. Make a jig and use a large trammel to mark the F&H wheel at that diameter. Cut the F&H wheel at the markings- probably a plasma cutter with a plywood circle as a guide would be best. Slip the modified C rim over the F&H wheel and weld in place- a MIG welder probably would be the neatest way. Other bad places on the F&H wheel should be patched and ground to shape before welding the C rim in place. This repair is a lot of labor.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|