Farmall & IHC Tractors Discussion Board |
Need help, crankshaft pulley
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Reddog on December 19, 2002 at 19:24:39 from (66.103.239.80):
I have been reading all the posts the last couple of months concerning removing the crankshaft pulley. Well I finally tried to take mine off my Super A tonight, no luck. It doesn't have any set screws, I have been spraying PB Blaster all over it for two days previous. I have a heavy duty puller that pulls on the back of the pulley not the edges. I heated it up and tried to pull it off, I ended up bending a solid 1" bar of steel on the puller and the pulley never moved a bit. What do I need to do ??? Thanks for the help.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|