Farmall & IHC Tractors Discussion Board |
Re: M tuning
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on December 17, 2002 at 10:22:24 from (63.147.130.2):
In Reply to: M tuning posted by David on December 14, 2002 at 18:08:53:
The mag should have an impulse if I am not mistaken. That is what clicks when you turn engine over. It works off of rpm (note that it quits clicking when tractor reaches a certain rpm). Is what this does is there is a catch in the mag. The engine should be timed before top dead center. This catch in the mag actually stops the mag from turning for real small amount of time and then it trips making the click sound and releases spark. This time delay moves the spark from being delivered to engine from before top dead center to after top dead center making start up much easier. That is how the impulse works. (Note that the engine must be timed with the impulse not working.) I am not sure how to inactivecate the impulse on an M. If you timed engine with impulse working then your timing is probably off. Other than the impulse I would say that the mag is unaffected by rpm.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|