Farmall & IHC Tractors Discussion Board |
Re: F-20 motor problems
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmalldan on December 16, 2002 at 06:02:32 from (64.154.26.248):
In Reply to: F-20 motor problems posted by Jeff on December 15, 2002 at 19:40:39:
Jeff, Are you trying to remove sleeves from the locked up engine? If so, they will likely be pitted and unusable. If the pistons are out, you can use a sleeve puller to remove the sleeves without damage. Generally, sleeves are available as replacement parts. Cost ($50-60 per sleeve) is such that you can almost buy sleeve kits for the same money as sleeves and rings. Check with your NAPA store or other full line auto parts store. Parts for the F20 are getting scarce and it may be the exception. I am not aware of other IHC engines that have parts which will interchange with the F20. The 3-7/8 bore "M" pistons might could be adapted to a overbored F20 sleeve, but the "M" dry sleeves will not work in the F20 block.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|