Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Can some one please explain the MW hand clutch?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon from Indiana on December 15, 2002 at 20:29:52 from (216.176.156.35):
In Reply to: Re: Re: Can some one please explain the MW hand clutch? posted by Sean on December 14, 2002 at 19:10:26:
Before live hyd. you stated the baler or combine with trans mission out of gear. When you had the pto at speed you push in clutch and speed shifted and started in a smooth motion as possible, fact it could be done. Later on we bought an overriding cluth that went on the pto and worked like a ratchit wrench. When you had the pto up to speed you push in the clutch and it started clicking as it worked till you put tractor in gear and could start much smoother. Jon
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|