Farmall & IHC Tractors Discussion Board |
Belt change
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andy Kopel on December 02, 2002 at 17:08:11 from (12.45.76.149):
OK, I know this is an easy one for all of you old timers, but it will give you a good chuckle anyways. I have a Farmall 350 and noticed that the v-belt that runs between the water pump/radiator fan sheave and a lower sheave is shot and needs to be replaced. I have two questions pertaining to this issue: 1) What does this lower sheave drive? I believe the hydraulic system is driven off of the timing chain and for the life of me can not figure out what this lower sheave is powering. 2) What is the easiest way to change the belt. I've been toying with removing the lower sheave, but it is tight in there and I'm hoping that there is an easier solution. As always, any advise would be appreciated. Thanks, Andy
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|